In this project, you will learn how to drive motors with L293 and Arduino UNO as the controller L293D can also be used to drive servo motors.
The l293d motor driver ic is a 16-pin Moto. L293d ic is used to control speed and direction of dc motor.
So be careful with choosing the proper motor according to its nominal voltage and current Control DC Motors with L293D Motor Driver IC & Arduino Each channel of this module has the maximum current of 1.2A and doesn't work if the voltage is more than 25v or less than 4.5v. OUT1/OUT2 und OUT3/OUT4 sind die Pins, die an die Motoren führen L293D shield is a driver board based on L293 IC, which can drive 4 DC motors and 2 stepper or Servo motors at the same time. IN1/IN2 und IN3/IN4 sind die Pins, die an den Raspberry führen und zum steuern der Richtung der jeweiligen Seite verantwortlich sind. Schaut man sich die L293D genau an, sieht man, dass sie symmetrisch aufgebaut ist: EN1 und EN2 sind für die jeweilige Seite die PWM Steuerung.
Each chip contains two full H-bridges (four half H-bridges). If playback doesn't begin shortly, try restarting your device.
L293d is a suitable device to use for stepper motors, gear motors etc. It can simultaneously control the direction and speed of two DC motors.